EN
Additional information about your energy efficient surge protector
Features
Your energy efficient surge protector is specifically designed to fit within your
home theater setup. You can conveniently control the on/off of your devices in
either zone 1 or zone 2 outlets with your remote control. When switched to
TV
the off position, it eliminates the consumption of the stand-by power to these
outlets, bringing energy savings to your fingertips.
STB
AMP
DVD
Zone 1 & 2 outlets group your devices by usage.
Always on outlets remain on even when other outlets are switched off –
these are ideal for devices which have volatile memory and require constant
power. (i.e. cable modems, DVRs , set top boxes, etc)
Zone 1
Remote control turns your devices on/off in zone 1 & zone 2 with the touch
of a button.
Always on
Zone 2
Cable management clips help eliminate cable clutter.
Remote control
LED indicators on the front of the unit provide worry-free protection and
show that your surge protector functions properly.
Cable management clips
Grounded – (green) shows that the outlets in your surge protector are
properly grounded.
Protecting – (red) shows that your surge protector is actively protecting
your devices.
GROUNDED
Zone 1 & Zone 2 – (green) lights to show that the group of outlets have
been switched on.
ZONE 1
ZONE 2
PROTECTING
Instructions for changing the remote control
battery
RF Remote Contro
FCC ID: OYMSPP5107C
This device complies with
15 of the FCC Rules.
Op
followeinrg two conditions
ation is subject to the
This device may not cause
l
(
harmful interferen
1
)
(
2
)
This device must accept an
i
n
t
e
i
n
r
fe
t
un
e
part
r
r
e
f
d
e
n
C
esiredr opercatio
e
e
n
ce that may causee
h
:
received,inccluding
,
.
A
a
n
d
n
Made in Chin
y
a
NOTE: If the remote control device stops working, replace the battery.
Step 1 -Turn the unit over and slide open the battery compartment cover.
Step 2 - Remove and dispose of the old battery properly. Do not throw the old
battery in the trash.
Step 3 - Insert a new battery and close the compartment cover. Replace ONLY with a 3 volt CR2032 type button
cell battery.
NOTE:The remote control with this unit operates on either channel A or channel B frequency. If you have purchased
more than one unit, make sure you have two different frequencies (A and B) as indicated by stickers on the bottom of
the unit and on the packaging.
PWR SRG_insert_17_EN_V1.0
Wk10113
|